Removing The Power Supply Converter - Cisco Catalyst 6807-XL Hardware Installation Manual

Removing the Power Supply Converter

If the system is powered on and PSC is installed properly, the PSC STATUS LED is green.
Figure 18: Installing the PSC
1
Removing the Power Supply Converter
To remove the PSC, perform these steps:
Before You Begin
• Ensure that the system (earth) ground connection has been made. For ground connection instructions,
• You may require a flat-blade or Number 2 Phillips-head screwdriver to loosen the screw on the PSC.
Cisco Catalyst 6807-XL Switch Hardware Installation Guide
58
Power rail connectors
see Establishing System Ground, on page
2 Mounting screws (one for each PSC)
41.
Removing and Replacing FRUs
OL-30656-01