Cisco Catalyst 6807-XL Hardware Installation Manual page 62

Installing AC Power Supplies
The slot inside the power supply bay ensures that PSM is installed in only one direction.
Tip
Figure 15: Installing the Power Supply Module
1
2
Step 4
Rotate the latch up and tighten the captive installation screw to lock the latch in place.
Step 5 Plug the AC power cord (connected to a power source on one end) into the corresponding power entry module
(PEM). For example, if you have installed the PSM in bay 1, plug the power cord into AC1.
For a list of supported AC power cords for your particular AC input power supply, see
AC Power Cords, on page
Step 6 Tighten the screw on the cable clamp next to the PEM. This ensures that the power cord is not accidentally
pulled out. See callout (5) in
Cisco Catalyst 6807-XL Switch Hardware Installation Guide
52
Slot in the power supply bay
Nub on the PSM that slides into the slot
67.
Figure 16: PSM and PEM, on page 53
Removing and Replacing FRUs
3 Latch
4 Captive installation screw
3000 W Power Supply
OL-30656-01