Supervisor Engine; Modules - Cisco Catalyst 6807-XL Hardware Installation Manual

Product Overview
Finding Serial Numbers, on page 106

Supervisor Engine

The switch supports these Supervisor Engine 2T models:
• VS-S2T-10G
• VS-S2T-10G-XL
Note The term supervisor engine is used to refer to Supervisor Engine 2T.
The following requirements apply to the supervisor engines installed on the switch:
• Install a 3000 W or higher-capacity power supply.
• Install supervisor engines only in slot 3 or 4.
• In systems with redundant supervisor engines, both the supervisor engines must be of the same model
• Each supervisor engine must have the resources to run the switch on its own, which means that all the
The uplink ports are fully functional on all redundant supervisor engine models when they are in the standby
mode. For more information, see the
Engine 2T" section in the
Related Topics
Connecting the Supervisor Engine Console Port , on page 46

Modules

The switch supports the following Cisco Catalyst 6500 Series Ethernet modules:
• WS-X6704-10GE
• WS-X6908-10G-2T and WS-X6908-10G-2TXL
• WS-X6748-GE-TX
• WS-X6848-TX-2T and WS-X6848-TX-2TXL
• WS-X6748-SFP
OL-30656-01
If the slots are not occupied by supervisor engines, you can install service modules. However, you cannot
install Ethernet modules in slot 3 and 4. Check your software release notes for any restrictions on the
type of module that can be installed.
and have the same daughter card configurations.
supervisor engine resources are duplicated. Identical supervisor engine memory configurations are
recommended, but are not required, as long as the supervisor engine with the smaller memory
configuration is sufficient to run the configured features of the switch. Additionally, each supervisor
engine must have its own flash device and console port connections.
Catalyst 6500 Series Switch Supervisor Engine
Catalyst 6500 Series Switch Module Installation Note
Cisco Catalyst 6807-XL Switch Hardware Installation Guide
Supervisor Engine
and the "Supervisor
Guide.
3