Cisco Catalyst 6807-XL Hardware Installation Manual page 52

Establishing System Ground
Procedure
Step 1 Use a wire-stripping tool to remove approximately 0.75 inches (19 mm) of the covering from the end of the
grounding wire.
Step 2
Insert the stripped end of the grounding wire into the open end of the right-angled grounding lug.
Step 3 Crimp the grounding wire in the barrel of the grounding lug. Verify that the ground wire is securely attached
to the ground lug.
Step 4 Secure the grounding lug to the system ground connector with two M4 screws. Ensure that the grounding lug
and the grounding wire do not interfere with other switch hardware or rack equipment.
Figure 12: Locating and Connecting System Ground
1 System ground location
2 System ground connector
Cisco Catalyst 6807-XL Switch Hardware Installation Guide
42
4 M4 screws to secure the lug to the connector
5 Stripped end of the grounding wire inserted into the
open end of the right-angled grounding lug
Installing the Switch
OL-30656-01