Oil Pan, Removing And Installing (Rear Wheel Drive Models) - BMW 1999-2005 M3 Service Manual

Lubrication System
1 of 16
http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/1...
Oil Pan
The oil pan removal procedure requires
that the engine be supported from
above and the front suspension
subframe be unbolted and lowered
from the chassis.
Oil pan, removing and
installing (rear wheel drive
models)
Raise car and place securely on
-
jack stands.
WARNING!
Make sure the car is stable and well
supported at all times. Use a
professional automotive lift or jack
stands designed for the purpose. A
floor jack is not adequate support.
Remove splash shield from under
-
engine.
- Drain engine oil as described in
020 Maintenance
Remove air filter housing complete
-
with mass air flow sensor.
Install engine lifting equipment at front
engine lifting point and raise
approximately 5 mm ( inch) until engine
weight is supported.
On cars with automatic
-
transmission, remove ATF cooler
line brackets from oil pan and
from transmission.
Note:
119-2
2/25/2009 9:53 PM