BMW 1999-2005 M3 Service Manual page 616

Steering and Wheel Alignment
4 of 11
http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/3...
Remove front stabilizer bar anchors
-
and swing stabilizer bar down out of
the way. See
Suspension.
Remove pump mounting bolts (arrows)
and remove pump. Rear wheel drive
model shown.
Installation is reverse of removal,
-
noting the following:
Make sure all thread bores, bolts,
nuts, fluid couplings and mating
surfaces are clean, and inside
surface of multi-ribbed-belt is free of
grease and dirt.
Use new sealing washers when
reattaching power steering pressure
lines.
Make sure hoses have adequate
clearance from chassis. Do not
over-torque banjo bolts.
Fill and bleed power steering
system as described earlier.
Tightening torques
Hydraulic hoses to power steering
pump
M14 banjo bolt
M16 banjo bolt
Power steering
pump to bracket M8
self-locking nuts
Power steering
pump bracket to
engine block M8
self-locking nuts
310 Front
35 Nm (26 ft-lb)
40 Nm (30 ft-lb)
22 Nm (16 ft-lb)
22 Nm (16 ft-lb)
2/25/2009 10:29 PM