Hood Release Cable And Spring Pins, Adjusting - BMW 1999-2005 M3 Service Manual

Fenders, Engine Hood
4 of 6
http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/4...
minimal clearance. Turn stop disk to
move hood front stop further out.
Height at front of hood is set using
-
spring pins and rubber stop
buffers.
Hood release cable and spring
pins, adjusting
Before adjusting hood pins, be sure
the hood is aligned evenly to fenders
and front panel.
Make sure bowden cable, which
-
connects both hood locks
together, is seated in lock guide
on both left and right locks.
Loosen hood spring pin bolts (A) and
retaining hook bolts (B) at hood on left
and right sides only enough to allow
movement.
Turn rubber stop buffers over
-
headlights inwards to provide
clearance.
- Lower (but do not fully latch) hood
several times so pins on hood
center themselves in lower locks.
CAUTION!
Do not let hood lock with latch bolts
loose.
Tighten hood spring pin bolts and
-
latch bolts when alignment is
correct.
- Remove one screw from each
side, clean and coat with
2/25/2009 10:40 PM