Ser vi ce Pr ocedur es
Connecting Diskette and IDE Devices
To connect diskette and IDE devices, perform the following:
1)
Connect supplied ribbon cable to appropriate device as shown. Make sure cable is connected with
correct orientation.
backwards. If the cable or device is not keyed, connect pin 1 of cable to pin 1 of device's socket. Pin
1 of cable is on edge with colored stripe. Pin 1 of device's socket should be marked with an arrow at
one end of socket. If necessary, refer to the device's documentation for pin 1 orientation.
2)
Connect appropriate power cable to device.
3)
Replace and lock side panel.
C
4)
Connect external devices and restore power.
5)
Run BIOS Setup Utility to configure the computer.
E
L
NOTE
If only one IDE device is installed, make sure to use the ribbon cable connector
E
furthest from the Main Logic Board. Also, if IDE devices are installed in both internal
B
drive bays, make sure device's control/data connectors directly face each other.
R
Connecting Diskette Devices
S
Figure Legend
5
8
A
B
6
C
D
E
60
Most cables and sockets are keyed so it is impossible to connect them
Diskette Drive Component (Figure 3-25)
Power supply
Power connections
Diskette drive connections
Main logic board diskette drive connection
Diskette drives
D i gi t al C ELEBRI S Pent i um PC
M C S Logi st i cs Engi neer i ng - N i j m egen