Qaplus/Fe Error Messages - Digital Equipment CELEBRIS Pentium PC Service Maintenance Manual

Digital CELEBRIS Pentium PC

QAPlus/FE Error Messages

Component Messages
CPU Arithmetic Function Failed.
General Functions Failed.
Exception Interrupt in Protected
Mode.
Refresh Failure.
Logic Functions Failed.
Butterfly Cylinder Access Test
Hard disk
Failed.
Cylinder 0 Errors.
Random Cylinder Access Failed.
Linear Cylinder Access Failed.
Hard Controller Diagnostic Test
drive/controller Failed.
Questionable Controller Card.
Hard drives failed.
Floppy diskette Media Mismatch.
Drive Not Ready.
Write Protected Media.
Unformatted Media.
Floppy drive Floppy Drives Failed.
Battery/clock Clock Stopped.
Invalid Date.
RTC Interrupt Failed.
CMOS CMOS Clock Test Failed.
Serial port COM port failed.
Serial Chip Error.
Serial Compare Error.
Serial Timeout Error.
Video adapter Video Failed.
Error in Video Buffer.
MCS Logistics Engineering - Nijmegen
Solution
Reset CPU.
Replace CPU.
Low-level format hard disk.
Replace disk.
Run Setup, Check connections,
Reset controller, Replace controller,
Replace disk.
Use known good diskette.
Check size and density of diskette.
Close drive door.
Remove write protection.
Format diskette.
Check connections, Replace drive.
Run Setup.
Replace battery/clock.
Change time from Setup menu in QAPLUS.
Check COM device.
Check connections.
Replace COM device.
Replace COM device.
Replace video adapter.
Replace video adapter.
Troubleshooting
75