Expansion Slots; Celebris Pentium Low-Profile Expansion Slots - Digital Equipment CELEBRIS Pentium PC Service Maintenance Manual

Digital CELEBRIS Pentium PC

Expansion Slots

The computer automatically assigns the necessary resources to any installed Plug and Play-compatible
expansion board so it operates at maximum performance. If you plan on installing non-Plug and Play
expansion boards, it may be necessary to manually set jumpers on the board based on the computer
resources already allocated.

CELEBRIS Pentium Low-Profile Expansion Slots

The CELEBRIS Pentium Low-Profile computer models contain four slots for installing up to three ISA or
PCI expansion boards. These four slots are located on the computer's riser card.
NOTE Prior to installing non-Plug and Play expansion boards, run the ISA Configuration
Utility (ICU) to configure the computer to avoid resource conflicts.
Expansion Slot Type
Slot
J4 ISA
ISA
J3
PCI
J2
J1 PCI
NOTE Only one expansion board can reside in slot J3 and J2 at any one time. These slots
have to share the middle expansion slot opening at the rear panel
MCS Logistics Engineering - Nijmegen
Description
Supports full-length industry-standard 16-bit ISA expansion
boards.
Uses the top expansion slot at the rear panel.
Supports full-length industry-standard 16-bit ISA expansion
boards.
Uses the middle expansion slot at the rear panel.
Designated as a shared slot with PCI slot J2.
Supports full-length 32-bit PCI local bus expansion boards.
Uses the middle expansion slot at the rear panel.
Designated as a shared slot with ISA slot J3.
Supports half-length 32-bit PCI local bus expansion boards.
Uses the bottom expansion slot at the rear panel.
Service Procedures
33