Alcatel-Lucent OmniPCX Office Installation Manual page 83

You do not have a DHCP
server
Initializing the IP Touch set
To initialize the IP Touch set, refer to the table below.
For an initializa- Procedure
tion that is
Dynamic mode 1. Connect the power supply.
or Proprietary 2. Before initialization phase 5 starts, press i, then the # key.
dynamic mode
3. If the set was previously in static mode, choose IP Parameters from the Main
4. Choose Dynamic.
5. Save by pressing the soft key in the upper left part of the display.
6. Exit the Main menu by pressing the soft key in the upper right part of the display.
Static mode
table 4.20: Initialization procedure
The Main menu appears.
menu.
The IP Parameters menu appears.
- Refer to table: Initialization
procedure
- Obtain from your network
administrator:
• An IP address for the
IP Touch set
• The subnetwork mask
• The router address
• The TFTP server ad-
dress (master VoIP
board address)
Note:
You need to know your set's
directory number.
4-45