Alcatel-Lucent OmniPCX Office Installation Manual page 78

Chapter
4
You do not have a DHCP
server
Initializing the IP Touch set
To initialize the IP Touch set, refer to the table below.
Note 1:
In each of the two cases below, you can view the IP Touch set's software version after Step 2 by select-
ing Version in the Main menu.
For an initializa- Procedure
tion that is
Dynamic mode 1. Connect the power supply.
or Proprietary 2. After initialization phase 2 is completed and before phase 5 starts, press i, then
dynamic mode
3. If the set was previously in static mode, choose IP Parameters from the Main
4. Choose Dynamic and press the OK key.
5. Save by pressing the # key.
6. Exit the Main menu by pressing the * key.
4-40
Static mode
table 4.18: Initialization procedure
the # key.
The Main menu appears.
menu.
The IP Parameters menu appears.
- Refer to table: Initialization
procedure
- Obtain from your network
administrator:
• An IP address for the
IP Touch set
• The subnetwork mask
• The router address
• The TFTP server ad-
dress (master VoIP
board address)