Alcatel-Lucent OmniPCX Office Installation Manual page 131

During installation, always take anti-static precautions (wristband, heelpiece, etc.) before
handling the hard disk. Any degradation caused by electrostatic discharges will reduce
the life of the disk.
When going into stand-by mode, wait for the red Power LED to stop flashing before you
remove the module's
standby is completed can destroy part of the disk or damage its contents. Never handle
the hard disk until the motor has stopped completely (about 4 seconds after the red Power
LED stops flashing).
4.12.1.4 Adding a Module
Figure 4.81: PATA Hard Disk Connection
Figure 4.82: SATA Hard Disk Connection
Handle the hard disk by its sides and do not touch the connector.
CPU PowerCPU
Expansion
board. Extracting the disk before the switch to
4-93