Accessing The System - Alcatel-Lucent OmniPCX Office Installation Manual

Chapter
6
Window 7 (32/64 bits), Windows server 2008, Windows server 2008 R2.
- Hard disk:
- Screen: 800 x 600 pixels
- 1 mouse
- 1 serial port (connection to Alcatel-Lucent OmniPCX Office Communication Server for data
transfer)
- 1 Ethernet board (IP mode only; not required when there is a V24 serial port connection to
Alcatel-Lucent OmniPCX Office Communication Server)
- 64K (1 B-channel), or 128K (2 B-channels) PPP-compatible ISDN modem, or V34 modem
for remote access
Note:
Before installing OMC, if the framework .NET is not installed on the PC, OMC will install it.
6.2.2.2 Installing the OMC Software
The OMC software is installed from a CD-ROM.
Install the application by choosing options in the various windows.
When installation is finished, you access the application either:
- by double-clicking on the new icon created on the Windows desktop, or
- by selecting Start -> Program -> Alcatel-Lucent OmniPCX Office Communication
Server -> OMC. The window Welcome to OMC appears.
Caution 1:
When a PM5 version (former management application) is installed on a PC where an OMC version
is already installed, the OMC version has to be reinstalled.
6.2.3

Accessing the System

6.2.3.1 Local Access By LAN
The default IP address for the main CPU board is 192.168.92.246 for:
- A connection to the LAN port on the main CPU board via a UTP Category 5 5-100 ohm
crossover cable.
- A connection to the switch to which the main CPU board is connected by a direct cable.
The PC IP address and network mask must be compatible with the address of Alcatel-Lucent
OmniPCX Office Communication Server. For example 192.168.92.1 and 255.255.255.0.
For security reasons, the OmniPCX Office can be configured with an additional IP address,
which is used only for management of OmniPCX Office.
6.2.3.2 Local V24 Access For OMC
It is possible to use OMC software to dialog with OmniPCX Office using a V24 connection. In
this case the network connection is not necessary.
A specific reinforced cable must link the "Config" RJ45 connector on the system CPU to the
Com port of the PC using OMC.
6-10
300 MB (recommended for installation and operation)