Alcatel-Lucent OmniPCX Office Installation Manual page 70

Chapter
4
supply for one minute. During this time, check that the system is still powered.
4.3.1.3.5 Installation of External Batteries for the
Platform
You must first prepare the external battery unit for use and then connect this unit to the
Alcatel-Lucent OmniPCX Office Compact Edition
platform . These two phases of installation are presented below in separate procedures.
Before starting the installation, note that:
- External batteries must be of the same type, supplied by the same manufacturer and from
the same batch run.
- Batteries must be charged prior to installation.
Preparing the External Battery Unit
1. On the external battery unit (see the figure below):
a. Ensure that the mains power cable is NOT connected.
b. Ensure that the ON/OFF switch is set to the OFF position (O or black).
c. Ensure that the J1 jack is NOT connected to the
Compact Edition
d. Open the unit by removing the four screws (ST3.5x32) with a screwdriver (Phillips
PH2).
2. Insert the batteries in the open unit as follows (see the figure below):
a. Place the first battery in the middle position (battery B1).
b. If a second battery is to be used, place this battery in the remaining position (battery
B2).
4-32
OmniPCX Office RCE Compact
OmniPCX Office RCE Compact
OmniPCX Office RCE Compact
Alcatel-Lucent OmniPCX Office
unit platform .
unit