Alcatel-Lucent OmniPCX Office Installation Manual page 133

RJ45 pin
MAIN:
- MAIN: HSL to basic module.
4.12.1.4.3 Role of the # key
Name Color
POWER Red/Green
FAN Red/Green
4.12.1.4.4 Adding a third module
- Replace the HSL1 board of the
- Reuse this HSL1 board by placing it on the
In an installation using two modules, the
PowerMEX
4.12.1.5 Installation Upgrade
This section outlines the major considerations to be taken into account when migrating to R8.x
from:
- R3.x
- R4.x
- R5.x
- R6.x
- R7.x
Because of the hardware changes in R8.0, all the R8.0 upgrade must be considered as an
on-site procedure.
The following procedures are based on minimal hardware configurations. For other services,
such as VoIP, enhanced VMU and ACD statistics, additional hardware is used and must be
taken into consideration.
1 2 3
TX+ TX- RX+
( add on module expansion
4 5
Feature
- Mains operation: steady green led
- Battery operation: steady yellow led
- Standy: steady red LED
- Both fans functioning: steady green led
- 1 or both fans down: steady red led
CPU PowerCPU board with an HSL2 board.
MEX PowerMEX
CPU PowerCPU
) boards are fitted with an HSL1 board.
6 7 8
RX-
board of the third module.
(base module) and MEX
4-95