Symbol Spectrum24 AP-3020 Reference Manual page 63

Spectrum24 Access Point AP-3020 Product Reference Guide
Ethernet Timeout Disables the radio interface if no activity is detected
Telnet Logins
System Password For administrative access, select any alphanumeric,
Agent Ad Interval Specifies the interval in seconds between the mobility
S24 Mobile IP
on the Ethernet line after the seconds indicated (30-
255). The AP disassociates MUs and prevents further
associations until it detects Ethernet activity again.
The default value
0
detects if the 10Base-T line goes down.
If the value is set to 2, the WLAP sends a WLAP Alive
BPDU on the Ethernet line every WLAP Hello Time
seconds to allow WLAPs on the Ethernet line to detect
its existence.
If the value is set to 3, the WLAP tracks the WLAP
Alive BPDU. If the BPDU is missing for WLAP Hello
Time seconds, the WLAP state changes to WLAP Lost
on Ethernet. Once the WLAP Alive BPDU is detected,
the WLAP resets and starts over.
Note: when the Ethernet connection is broken:
- If the WLAP mode is disabled, the AP clears the MU
table and disables the RF interface until the Ethernet
connection comes up.
- If the WLAP mode is enabled, the AP sets the
timeout value to zero (0), resets itself and attempts to
associate with another WLAP in the network.
Specifies if the AP accepts or rejects Telnet Logins.
The default value is Enabled.
case-sensitive entry up to 13 characters for a
password. The default System Password is Symbol.
agent advertisement transmission.
If enabled, this feature allows MUs to roam across
routers.
Configuring the AP
disables this feature. The 1 value
55