Quick Wireless Ap Setup - Symbol Spectrum24 AP-3020 Reference Manual

Introduction
When using a wireless AP-to-AP connection, use the optimal antenna
configuration for the site. For example, use a directional antenna when
establishing a dedicated wireless bridge or repeater.
•
Using more than two WLAPs to establish a connection slows network
performance for all topologies. If not using the AP Auto Configure feature,
disable WNMP Functions and AP-AP State Xchg parameters under the Set
System Configuration screen to increase WLAP performance.
WNMP is a Wireless Network Management Protocol.
1.2.2

Quick Wireless AP Setup

To set up an AP for wireless operation automatically, select the
option for the WLAP Mode parameter. To set these values,
Configuring Radio Parameters on page 43.
The WLAP initialization process length depends on the time specified in the
WLAP Forward Delay field.
43.
8
A wireless AP network is possible, depending on the network bandwidth
and configuration. Each wireless AP can have connections with up to
four other wireless APs.
See 2.5 Configuring Radio Parameters on page
Spectrum24 Access Point AP-3020 Product Reference Guide
Enabled
See 2.5