Table of Contents
Advertisement
Turn Signals
Move the multifunction lever up or down and the
arrows on each side of the instrument cluster
display flash to show proper operation of the
front and rear turn signal lights.
NOTE:
• If either light remains on and does not flash,
or there is a very fast flash rate, check for a
defective outside light bulb. If an indicator
fails to light when the lever is moved, it would
suggest that the indicator bulb is defective.
• A "Turn Signal On" message will appear in the
instrument cluster display and a continuous
chime will sound if the vehicle is driven more
than 1 mile (1.6 km) with either turn signal on.
Lane Change Assist — If Equipped
Tap the multifunction lever up or down once,
without moving beyond the detent, and the turn
signal (right or left) will flash three times then
automatically turn off.
44
INTERIOR LIGHTS
The interior lights come on when a door is
opened.
To protect the battery, the interior lights will turn
off automatically ten minutes after the ignition is
moved to the OFF position. This will occur if the
interior lights were switched on manually or are
on because a door is open. The Battery Protec-
tion also includes the glove compartment light
and the trunk light. To restore interior light
operation after automatic battery protection is
enabled (lights off), either place the ignition in
the ON/RUN position or cycle the light switch.
Courtesy Lights
The courtesy lights can be turned on by pushing
the top corner of the lens. To turn the lights off,
push the lens a second time.
Courtesy Lights
Front Map/Reading Lights — If Equipped
The front map/reading lights are mounted in the
overhead console.
Front Map/Reading Lights
Each light can be turned on by pushing a switch
on either side of the console. These buttons are
backlit for night time visibility. To turn the lights
off, push the switch a second time. The lights will
also turn on when the unlock button on the key
fob is pushed.
Front Map/Reading Light Switches
Advertisement
Chapters
Table of Contents
