How To Set Up - Britax 7300/B/2010 Series Instructions For Installation And Use Manual

SUITABLE FOR USE - REARWARD-FACING
DO NOT USE RESTRAINT IN REARWARD-FACING MODE WITHOUT
STABILISING BAR FULLY EXTENDED.
Do not use the restraint without the Upper Anchorage Strap
correctly attached.
DO NOT USE A REAR-FACING CHILD RESTRAINT WHERE AN
AIRBAG IS FITTED IN FRONT OF THE SEATING POSITION.
Do not use on any vehicle seat which faces sideways or rearwards.
Never leave babies or toddlers in a stationary car in the sun because
of the risk of heat exhaustion.
Ensure babies and toddlers have adequate ventilation and are
shaded from direct sunlight through side or rear windows.
14
Do not allow the front seat to
alter the installed position of
the restraint. It is permissible to
allow the restraint to touch the
seat on front of it.
CONVERT TO BABY USE MODE (Model with base)
A. To fully recline the restraint into Child use mode, place one hand
on the front corner of the base firmly, lift recline latch up to
unlock, continue pulling restraint forward until fully reclined or
unable to recline further.
B. Once fully reclined in Child use mode, pull the latch located
behind the restraint body, continue pulling the restraint forward
until fully reclined into baby use mode.
HOW TO SETUP
Lift Recline Latch
15