Britax 7300/B/2010 Series Instructions For Installation And Use Manual page 14

HOW TO INSTALL
FITTING SUMMARY
A single
twist is
required in
baby use.
Pull to remove
slack - do not
over tighten.
DO NOT USE RESTRAINT IN REARWARD-FACING MODE WITHOUT STABILISING
BAR FULLY EXTENDED.
THE UPPER ANCHORAGE STRAP MUST ALWAYS BE FITTED WHEN THE CHILD
RESTRAINT IS USED IN A VEHICLE.
ALWAYS ATTACH THE HOOK AND REMOVE THE SLACK.
26
Hook Attachment Clip to
the car's anchor fitting.
Ensure the Upper Anchorage
Strap is tightened, attached to
the Anchor Fitting and that straps
are the same length on both
sides of the Attachment Clip.
Pull sash portion of seatbelt to
remove slack.
Feed seatbelt between restraint
cover and restraint body.
IMPORTANT:
If using an Extension Strap, positioning the Attachment Clip above the baby may lead to injury in an
accident therefore make sure that the Attachment Clip is not positioned in front of the vehicle seat.
Attachment Clip should
not be in front of the
vehicle seat front.
HOW TO INSTALL
Attachment Clip
should be behind
the front of the
vehicle seat front.
Extension
Strap
Attachment Clip
27