Britax 7300/B/2010 Series Instructions For Installation And Use Manual page 28

CARE & MAINTENANCE
TO REPLACE COVER:
A. Stretch the cover over the top of the
restraint first, then the sides. Feed Harness
Tongues and shoulder straps through the
Lap strap slots on the cover.
B. Stretch the cover around the rim of the
restraint, Hook elastic loops at the back
of the restraint and under the front of the
restraint, there are 4 places.
C. Feed the Crotch Buckle through slots in
cover.
D. Ensure the cover is stretched over Push
Button housing if fitted with a Harness
Adjustment Button. (If fitted with a Harness
Adjustment Lever, pull the adjuster strap
through the cover). Ensure none of the
harness straps are twisted.
E. Refit the harness strap by feeding through
the previous shoulder strap slots. If you
don't recall the slots used refer to pages
17, 18, 19 or pages 40, 41, 42. You MUST
thread the shoulder strap OVER cross bar
and then re-attach the straps to metal strap
connector at the back of the seat (see page
42). Check that the straps are connected.
F. Refit the Padded Insert (if required) and any
other accessories if required.
G. Refit to the vehicle.
54
Feed Harness Tongues and
shoulder straps through the
Lap strap slots on the cover
A
Hook elastic loop at the back
of the top of the restraint
Cross Bar
B
Cross Bar
E
E
Metal Strap Connector
IMPORTANT:
ONLY USE SAFE-N-SOUND SEAT COVERS AND ACCESSORIES THAT ARE DESIGNED AND TESTED
FOR USE WITH THIS PRODUCT.
The following instructions apply to accessories that may be supplied with this restraint at point of
purchase. If not, a variety of accessories are available from various retailers of Safe-n-Sound products.
CANOPY (IF FITTED)
The Canopy has been designed to shade your child from direct
sunlight.
A. Attach the elastic straps at the back of the canopy to the
hooks at the rear of the restraint.
B. Attach together the button/studs sewn on the ends of the
hood and on the sides of the trim.
HEAD PILLOW (IF FITTED)
The head pillow (if fitted) is designed to provide extra comfort
and may be one of two styles.
Style 1. Head Pillow loose.
Position the bottom of the head pillow level with the top of the
child's shoulders. Ensure the upper strap is always over the top
of the restraint and the lower strap can be threaded through the
slot above the harness straps (see illustrations).
Loop over to bottom
Feed through middle sot
slot and pull to tighten
ACCESSORIES
Hooks
Button/
studs
Adjuster
Head
pillow
Strap for
adjusting
the pillow
Harness strap
55