Britax 7300/B/2010 Series Instructions For Installation And Use Manual page 12

HOW TO INSTALL
D. Remove Padded Insert (if fitted), and
gently lift back trim end, then pull the
centre panel flap backwards, with the
comfort pad from the inner seat of trim.
See Fig 2.
E. Fully lengthen the car's seatbelt and feed
the seatbelt between the restraint cover
and the restraint body through seatbelt
slots in restraint. See Fig 2.
22
Padded Insert
D
Centre panel flap and
comfort foam (if fitted)
Fig 2.
Backing trim
E
Pass buckle tongue through here
F. Engage the seatbelt buckle and tongue.
Tighten the seatbelt allowing the sash to
fully retract.
NOTE: Seatbelt buckle and tongue must
not rest between restraint cover and
restraint. If seatbelt buckle is adjustable,
adjust the buckle as low as possible
away from the restraint.
G. Replace the back and centre panel of
the cover properly. Ensure the harness
buckle is through the panel, and connect
the hook and loop to retain the cover.
For smaller babies replace the Padded
Insert (if fitted). Do not use if the child's
shoulders reach the lower Shoulder
Height Marker. See page 17 and 19
for advice on positioning the shoulder
straps.
NOTE: Seatbelt extenders should not be
used if the seatbelt is not long enough
to secure the child restraint. If they are
used then the buckle must not enter the
seating zone.
HOW TO INSTALL
F
Pass buckle tongue through slot here
G
C
23