Britax 7300/B/2010 Series Instructions For Installation And Use Manual page 9

HOW TO SETUP
CONVERT TO BABY USE MODE (Model with foot)
Move Recline Foot by squeezing the Foot, squeezing the Recline Foot Handle while rotating to the baby
position (refer to label on the side of the restraint) until the handle locks into position. Ensure Recline
Foot locks into position.
Rotate Recline
Foot to baby
position
Recline position
indicator
Pull out
16
Squeeze Recline Foot
Handle to adjust
Rotate
ADJUSTING HARNESS STRAP HEIGHT: FOR BABY USE
REARWARD-FACING
Correct fitment of the harness is very
Lower shoulder height marker
important as it restrains the child in the
restraint. The harness must fit firmly
around the upper torso of the child and be
positioned so as to leave the child's arms
and legs free.
The shoulder straps must be in the slots
which are nearest to the child's shoulders,
but not lower than the child's shoulders.
If your baby's shoulders have reached
the lower shoulder height marker then the
restraint should be converted for "child
use"(Refer to Forward-facing section page
33).
The harness adjuster is fitted in different
styles on different models. There is a push
button adjuster that must be pressed to
loosen the harness and there is a lever
operated adjuster that is fitted under a flap.
Check your child restraint to see which
version you have.
HOW TO SETUP
Harness strap
Shoulder slots
Shoulder harness
straps
Harness tongues
and buckle
Lap strap slots
Crotch strap slots
Harness Adjustment
Button or Harness
Adjustment Lever
under flap
Harness adjuster strap
17