How To Use - Britax 7300/B/2010 Series Instructions For Installation And Use Manual

HOW TO INSTALL
ANGULAR ADJUSTMENT OF RESTRAINT
Some vehicle seats have more rearward slope than others. If the angle of the seat causes the baby to
be too upright for comfort, the angle may be altered by placing a firm packing between the seat and
the underside of the base. Packing can be a firmly rolled up towel or nappy.
Do not remove all of the rearward slope by over packing. Always leave a rearward slope angle of
approximately 10 to 15 degrees as shown
10° to 15°
10° to 15°
28
Model with Base
Model with Foot
PLACING BABY INTO RESTRAINT
A. Ensure the shoulder straps are positioned to the correct height for your child (see pages 17 to 19).
B. Slacken the Harness Straps by pushing and holding the Harness Adjustment Button, grasping
BOTH shoulder harness straps and fully lengthen.
Alternatively if using a lever adjuster, lift lever and slacken the harness.
Place the buckle tongues over the side of the seat so that the baby does not lay on them.
C. Lay baby on their back into restraint and fit the harness as shown above. Make sure the baby is
dressed to allow harness buckle to be pulled up between the baby's legs e.g. a jump suit. Make
sure the baby's arms and legs are free. Never wrap baby in a blanket before placing in restraint.
Lower shoulder
height marker
Harness shoulder
straps
Upper shoulder
height marker
Adjuster for the Upper
Anchorage Strap

HOW TO USE

Slackened Upper
Anchorage Strap
Car's
Anchor
fitting
Adjuster Strap
Harness Adjustment Button
Alternative Harness
Adjustment Lever
29