How To Set Up - Britax Safe-n-Sound BS4900A-020130 Series Instructions For Installation & Use

HOW TO SETUP
UNFOLDING THE BOOSTER SEAT
If the seat is in a folded position, grip the
Booster seat back and seat base and unfold
till you hear it lock into position. Check that
the seat has locked into position.
CAUTION:
DO NOT PLACE FINGERS IN BETWEEN
SEAT BACK & SEAT BASE WHEN
FOLDING OR UNFOLDING. RISK OF
TRAPPING HAND/FINGER
FOLDING THE BOOSTER SEAT
To store the Booster seat, push to fold the
seat forward.
BEFORE INSTALLING THE
SEAT IN TO THE CAR
Place child in booster seat and check height
for headrest and SecureGuard™ Device set
up. Adjust as shown on pages 17 to 19.
Extend seatbelt if required.
16
Instructions for Installation & Use - Series No. BS4900A-020130
Seat
back
Seat
base
Check headrest position
Check and adjust
SecureGuard™
ADJUSTING THE HEADREST
A. The headrest can be adjusted to lock into different height
locations. This can be done with the child in the seat.
B. Hold backrest as shown and squeeze the headrest
adjustment handle at the back of the headrest with the
other hand, to move the headrest up or down.
CAUTION:
Keep hands away from gap at the back of the lower
backrest whilst adjusting.
C. Adjust the headrest height so that the bottom of the sash
guide is level with or just above your child's shoulder
(but not more than 30mm above).
Less than
30mm
D. When the headrest is in the correct position let go of the headrest adjustment handle and
ensure it has locked into place.
Do not adjust the headrest by pulling on the Side Impact Cushion.
Instructions for Installation & Use - Series No. BS4900A-020130
HOW TO SETUP
B
Greater than
30mm
17