Britax 7300/B/2010 Series Instructions For Installation And Use Manual page 13

HOW TO INSTALL
H. Align the restraint centrally within the
chosen seating position as shown
right. Pull the sash portion of seatbelt
until all slack is removed from Lap
portion of seatbelt. Adjust the seatbelt
to hold the restraint firmly against
the vehicle seat back. For retractor
seatbelts, allow excess belt to feed
back into retractor.
24
I. Fit the attachment clip to the anchor fitting as shown
right. Make sure to remove as many twists as
possible from the upper anchorage strap.
J. Tighten the adjustable upper anchorage strap by
pulling adjustment strap to remove slack. Do not
over-tighten causing the restraint base to lift off
the vehicle seat. This will usually be done once the
baby has been harnessed into the seat.
K. Roll up the excess strap tightly so the webbing is
thick enough to be held in the storage band.
HOW TO INSTALL
Attachment Clip
Car's Anchor Fitting
Fully press Adjuster Button (1)
while pulling Upper Anchorage
Strap (2) to lengthen.
1
2
Storage
Band 3
Pull Adjustment
Strap to remove
slack
Roll up excess
strap tightly so the
webbing is thick
enough to be held
in the storage band.
25