Britax 7300/B/2010 Series Instructions For Installation And Use Manual page 22

HOW TO SETUP
STEPS IN CHANGING SHOULDER
STRAP SLOTS
A. Remove the restraint from vehicle.
B. At the rear of the restraint, remove one of the harness
shoulder straps from metal Strap Connector by slipping
strap through open slot.
C. Pull the shoulder strap through slot.
D. Insert shoulder strap through the restraint slot which will
position shoulder strap level with or above the child's
shoulder, then over the metal bar. Ensure that the shoulder
strap passes through matching slots in cover and restraint
body.
E. Connect the shoulder strap to the metal strap connector at
the rear of restraint, ensuring that there are no twists in the
shoulder strap.
F. Repeat for other shoulder strap. It is better to change one
strap at a time so that the other strap will be a guide for
re-assembly.
If using the head pillow adjust the height using the adjusters
so the side wings of the head pillow are just above the
shoulders. See page 55 and 56 for adjustment method.
42
Bar
Pull
straps
INSTALLING INTO VEHICLE FORWARD-FACING
(UPRIGHT OR RECLINED)
For illustration of the installation method, the
drawings show the restraint with a base but the
method also applies with the recline foot version of
this child restraint.
A. Remove the seat from the vehicle by
disengaging the seatbelt and upper anchorage
strap.
B. Remove the padded insert (if fitted) as this is
no longer required.
C. To store the Stabilising Bar, lift the cover at the
end of the seat which uncovers the stabilising
bar storage recess.
D. Press the button on the left side (facing seat)
and gently push stabilising bar back and then
down into the recessed area.
E. Re-attach the cover at the end of the seat.
IMPORTANT:
DO NOT USE RESTRAINT IN FORWARD-FACING POSITION WITH THE STABILISING
BAR PULLED OUT.
Do not recline into baby position when using restraint in forward-facing child use
mode.
Ensure the harness is in the correct position (Refer to pages 40 to 42).
HOW TO INSTALL
Hook and Loop
attachment
Stabilising
bar
Rotate
Then push
backwards
inwards
Button under trim
43