Switching On And Off; Switching On; Switching Off; Backlight - B&G h1000 CND Manual

getting started
Page 8

switching on and off

Before turning the CND on, check that the
installation instructions in Appendix B ha ve
been correctly follo wed.

Switching On

Pressing the PWR key for one second switches
on the CND , you will first be presented with the
B&G logo screen and
information.
The CND will the n perform a short self test
procedure that checks internal memory and
displays any failure detected on the screen.
If installed, the C-CARD will also be tested.
After a few seconds, a Caution page is
displayed, reminding you that the chart plotter
is only an aid to navigation, and should be used
in co njunctio n with
practices.
Pressing any key will
cartographic scree n with a position if an
external GPS is connected.
The display can be customised for your
personal prefe rences
Settings section.

Switching Off

Press the PWR key and hold for three seconds,
a countdown timer appears on the screen,
when this reaches zero it will power off.
If you release the key before the countdown
timer reaches zero, the CND will remain on.
There are three levels of backlighting. To alter
the level of backlighting, press and release the
PWR key until the desired level.
cnd
so ftware version
normal navigational
then display the
using the System

backlight