B&G h1000 CND Manual page 54

appendix c
Deleting MOB
Names
Nav-Aids
NMEA-0183
Output Format
Plotter Mode
Plotter Setup (menu)
Port By Name
Page 54
terms and functions
To cancel the MOB mode, press and hold the
'MARK' key for two seconds.
Turns On/Off the displaying of the local area
names.
The default setting is On.
Turns On/Off the Buoys and Beacons.
The default setting is On.
The NMEA-0183 Data Interface Standard was
developed by the National Marine Electronics
Association of America. It is an international
standard that e nables equipment from ma ny
different manufactures
together and to share info rmation.
Disables (Off) or sets the interface among
0183, 0180, 0180/CDX. The default setting is
0183.
Selects whether areas not covered by the
electronic charts on the C-CARD can be
viewed. If set to On, then the user can zoom in
to view Marks, routes, tracks and boat's
position anywhere in the world down to a zoom
level of 0.008 Nm (Scree n width = 15 metres),
regardless of what charts are on the C-CARD.
If set to Off then the CND will only displa y the
areas covered by the chart. When the edge of
chart coverage is reached, the CND will
automatically zoom out to the next available
smaller scale chart.
The default setting is Off.
Enables/Disables the Plotter Mode and the
Position Correction, selects the desired value
for Position Offset, GPS Datum, Chart Datum.
Press the CLR key to return to the previous
menu.
To locate and display the port inserting the
name.
The icon list of the available services is shown
on the screen.
cnd
to be connected