B&G h1000 CND Manual page 55

cnd
terms and functions
Port Info
Ports and Services
Port Services
Position Correction
R/B
Resolution
Rolling Road (page in GPS Mode)
The Port Info function is a combination of a
new Port Info database containi ng all the
relevant Safety and Navigational information
normally found in good pilot books and a new
presentation software which displa ys special
Port Facility Symbols.
Turns On/Off the displaying of Ports and
Services.
The default setting is On.
To loca te and displa y the nearest available
facilities of a particular type (i.e. the nearest
Hospital, sailmaker, bank, etc.).
The icon list of the available services is shown
on the screen.
Allows the user to correct for any position
inaccuracy due to datum shifts or poor survey
data. This can sometimes occur in areas where
the original paper charts are produced from
very old survey data or where the chart has a n
unknown datum or datum that is not listed o n
the CND list of datums.
Allows the range and bearing between two
positions on the cha rt to be calculated
It is the resolution angle
Orientation, range [5 , 30] degrees. The default
setting is 15°.
From this page it is possible to display the next
targets bearing (BRG) and dista nce (DTG), go
on to the previous or next Target, or display the
Route Data Report.
appendix c
for the Map
Page 55