Setup Menu; Selecting Alarms; Anchor Drag Alarm; Hdop Alarm - B&G h1000 CND Manual

cnd

setup menu

Selecting Alarms

Use the CURSOR keypad to scroll to the
Alarms menu and pressing the ENTER key to
select.
Use the CURSOR keypad to enable the alarm,
then use the CURSOR keypad to select and
change the value of a setting , and press the
ENTER key to set.
When an alarm is activated the CND emits a
beep and a pop-up window is opened.

Anchor Drag Alarm

Triggers when the boat exits from the anchor
circle. The radius is set in the Alarm Value.

HDOP Alarm

This specifies the minimum quality of satellite
signal to receive an accurate position fix. The
higher the value , the less accurate the fix.
Above the set number, the alarm sounds.

Cross Track Alarm

This specifies the distance perpendicula r to the
rhumb line, exceeding this value triggers the
alarm.

Waypoint Arrival Alarm

Specifies the radius of a circle around the
Waypoint/Mark of a route. Whe n your boat
reaches this circle the alarm sounds.
settings
Page 35