Sensor Input; Relay Output - Digimerge VB300 SERIES Instruction Manual

SENSOR INPUT

Configure the sensors connected to the
system. Depending on your model, you can
connect from 4 to 16 sensors.
Figure 11.3 Sensor input menu
To set sensor input:
1. Press the
sensor channel. Press the
to switch between pages.
2. Press the buttons to set the value of
the sensor input:
• NORMAL OPEN: The sensor is open at
normal times
• NORMAL CLOSE: The senor is closed at
normal times
• NOT USED: No sensors are connected to
the system (default for all channels)
3. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SAVE AND EXIT
to save your settings.
buttons to select the
buttons

RELAY OUTPUT

Configure the relays on the system.
Figure 11.4 Relay Output menu
To set the relay output:
1. Select RELAY SELECT and press the
buttons to set the type of relay:
• REC
• USER
• POWER (N.C.)
• HDD ERROR
2. Select RELAY OUTPUT TIME and press
the buttons to set the length of the
relay time: 1~30 seconds.
3. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SAVE AND EXIT
to save your settings.
NOTE: You can set the Relay Output for
channels 1~4 by setting the relay to the
following:
• POWER: The relay is working when the
system is powered off
• USER: The user can operate the relay
manually: press the FUNCTION button
to operate Relay 4 manually.
NC— NO: and then press the
NO— NC: and then press the
Using the Main Menu
• MOTION
• LOSS
• ALARM
• NOT USED
button
button
37