Installing A Power Supply Unit; Concluding Steps - Fujitsu Primergy BX900 S2 Upgrade And Maintenance Manual

Power supply
6.2.3

Installing a power supply unit

Figure 14: Open release lever
Ê Open the release lever (1).
Ê Push the PSU as far as possible into the empty bay (2).
Ê Swivel the release lever down until it clicks into place under the locking lever.
6.2.4

Concluding steps

Perform the following procedures to complete the task:
Ê Connect the AC power cord to the PSU and secure it with a cable tie as
described in section
Ê If applicable, close the rack door as described in section
door" on page
Ê Configure PSU redundancy as described in section
supply redundancy" on page
94
"Connecting the system unit to the mains" on page
60.
81.
Upgrade and Maintenance Manual
"Closing the rack
"Configuring power
BX900 S2
50.