Fujitsu Primergy BX900 S2 Upgrade And Maintenance Manual page 165

I
Make sure that the connection of the
two cables does not come loose when
inserting the cable in the side cover.
Figure 64: Anchoring the front docking board
Ê Make sure that the LCD cable is completely inside the side cover.
Ê Connect the front docking board to the two guide pins (1) of the midplane
connector and push it forward as far as it will go. When it is in its final
installation position, it clicks into place in the side cover.
Ê Pull the free end of the new LCD cable out of the system unit using the old
cable.
Ê Remove the adhesive tape.
BX900 S2
Upgrade and Maintenance Manual
Front docking board
165