Table of Contents
Advertisement
Problem solving guide
Fault messages in the display
Message in the
display
q
Drainage
fault
p
Water inlet
fault
,
Technical
fault
,
Fault
Disinfection temp.
not
reached
A To switch off the fault message, press the OK button.
38
Possible cause
The water outlet is blocked
or restricted.
The drain hose has been
fixed too high.
The water inlet is blocked
or restricted.
There is a fault.
During the disinfection
programme the water
temperature was not
reached.
Remedy A
Check whether the
drainage system is
blocked.
Clean the drain filter and
the drain pump.
The maximum drain height
is 1 m.
Check whether
– the stopcock is opened
wide enough.
– the inlet hose is kinked.
Start the programme
again.
If the fault message
appears again, contact the
Service Department.
The machine has not
carried out the disinfection
cycle correctly.
Start the programme
again.
Advertisement
Table of Contents
