Table of Contents
Advertisement
Problem solving guide
The following fault messages appear in the display and the
programme stops
Message
Drainage fault
Clean the drain filter
and the pump.
Check the drain
hose.
Water intake fault
Open the stopcock
Technical fault F
If restart is
unsuccessful call
Service.
Waterproof system
reacted
Close the stopcock.
Call Service.
To switch off the fault messages: Switch the washing machine off with the
button.
70
Cause and remedy
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filters and the drain pump.
The maximum delivery head is 1 m.
The water inlet is blocked or restricted.
Check whether the stopcock is opened properly.
Check whether the inlet hose is kinked.
Check whether the water pressure is too low.
The filter in the water inlet is blocked.
Clean the filter.
There is a fault.
Disconnect the washing machine from the mains
electricity supply, either by switching off at the wall
socket and withdrawing the plug, or by
disconnecting the relevant fuse on the mains fuse
board.
Wait at least 2 minutes, before reconnecting the
washing machine to the mains electricity supply.
Then switch the washing machine on again.
Restart the programme.
If the fault message appears again, contact the
Service Department.
The water protection system has reacted.
Close the stopcock.
Call the Service Department.
Advertisement
Table of Contents
