Table of Contents
Advertisement
The following fault messages appear in the display and the
programme stops
Problem
Drainage fault
Clean the drain filter
and the pump.
Check the drain
hose.
Water intake fault
Open the stopcock
Technical fault F
If restart is
unsuccessful call
Service.
Waterproof system
reacted
Close the stopcock.
Call Service.
To switch off the fault messages: Switch the washing machine off with the
button.
Cause and remedy
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filters and the drain pump.
The maximum delivery head is 1 m.
The water inlet is blocked or restricted.
Check whether the stopcock is opened properly.
Check whether the inlet hose is kinked.
Check whether the water pressure is too low.
The filter in the water inlet is blocked.
Clean the filter.
There is a fault.
Start the programme again.
If the fault message appears again, contact the
Service Department.
The water protection system has reacted.
Close the stopcock.
Call the Service Department.
Problem solving guide
71
Advertisement
Table of Contents
