The Following Fault Messages Appear In The Display And The Programme Stops - Miele WKH 122 WPS Operating Instructions Manual

Problem solving guide
The following fault messages appear in the display and the
programme stops
Problem

Water intake See


Drainage See 

 Service Water-
proof syst.

 Service Fault F
To switch off the fault messages: Switch the washing machine off with the  but-
ton.
64
Cause and remedy
The water inlet is blocked or restricted.
 Check whether the stopcock is opened properly.
 Check whether the inlet hose is kinked.
 Check whether the water pressure is too low.
The filter in the water inlet is blocked.
 Clean the filter.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filters and the drain pumps.
 The maximum delivery head is 1 m.
The water protection system has reacted.
 Close the stopcock.
 Call the Service Department.
There is a fault.
 Start the programme again.
If the fault message appears again, contact the
Service Department.