Table of Contents
Advertisement
Fault messages in the display
Problem
q
Fault
Check drainage
system
p
Fault
Water intake
Open stopcock
o
Waterproof
activated
Close stopcock
ä
Fault
Drum lighting
,
Technical fault
Call the Service
Department
The following will flash in
the display:
Anti-crease
alternately with
Check detergent
A To switch off the fault message: Switch the washing machine off with I-On/0-Off
button.
Possible cause
– The water outlet is
blocked or
restricted.
– The drain hose has
been fixed too high.
– The water inlet is
blocked or
restricted.
The water protection
system has reacted.
The drum lighting is
not locked in position.
There is a fault.
Excessive foam has
built up during
washing.
Problem solving guide
Remedy A
– Clean the drain filter and
the drain pump.
– The maximum drain
height is 1 m.
Check whether
– the stopcock is opened
wide enough.
– the inlet hose is kinked.
Call the Service
Department.
Check that the drum
lighting is sitting correctly.
Start the programme again.
If the fault message
appears again, contact the
Service Department.
Use less detergent next
time and follow the
manufacturer's instructions
on dosage given on the
packaging.
37
Advertisement
Table of Contents
