Table of Contents
Advertisement
The following fault messages appear in the display and the
programme stops
Problem
Drainage fault
Water intake fault
Technical fault F
Waterproof system
reacted
To switch off the fault messages: Switch the washing machine off with the but-
ton.
Cause and remedy
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filters and the drain pumps.
The maximum delivery head is 1.8 m.
The water inlet is blocked or restricted.
Check whether the stopcock is opened properly.
Check whether the inlet hose is kinked.
Check whether the water pressure is too low.
The filter in the water inlet is blocked.
Clean the filter.
There is a fault.
Start the programme again. If the fault message
appears again, contact the Service Department.
The water protection system has reacted.
Close the stopcock.
Call the Service Department.
Problem solving guide
77
Advertisement
Table of Contents
