Dataport Configuration - TANDBERG MCU User Manual

Configure the MCU

Dataport Configuration

To configure the Data port on the MCU, open 'Dataport' as shown in the figure below.
Dataport Configuration is used to configure the RS 232 serial port on the MCU. If you want to connect a PC to the
dataport, you must ensure that the PC and the MCU are identically configured.
Configuration
Baudrate
Parity
Databits
Stopbits
Save
Press 'Save' to activate the new settings.
TANDBERG MCU
Possible values are: 1200 bps, 2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps,
56600 bps and 115200 bps.
Select 'None', 'Odd' or 'Even'.
Select 7 or 8 databits.
Select 1 or 2 stopbits.
NOTE
50
W
NOTE
HEN CONNECTING TO A
THE CONNECTING CABLE MUST
BE A STRAIGHT THROUGH
RS232 .
CABLE
T
HERE ARE NO HARDWARE OR SOFTWARE
. M
HANDSHAKE OPTIONS AKE SURE THE
PC OFF.
HANDSHAKING IS TURNED
PC