Table of Contents
Advertisement
Configure the MCU
IP Configuration
To configure the IP settings on the MCU, open 'IP' as shown in the figure below.
Configuration
IP Address Assignment
DHCP:
Dynamic Host Configuration Protocol can be selected when a DHCP server is present. Static IP
Address, Static IP Subnet Mask and Static IP Gateway are ignored because these parameters
are assigned by the DHCP server.
Static:
If Static assignment is used, the MCU's IP-address and IP-subnet mask must be specified in the
IP-address field.
IP Ethernet Speed
Auto
The MCU will automatically detect the speed/duplex on the LAN.
10Half
The MCU will connect to the LAN using 10 Mbps/Half Duplex.
10Full
The MCU will connect to the LAN using 10 Mbps/Full Duplex.
100Half
The MCU will connect to the LAN using 100 Mbps/Half Duplex.
100Full
The MCU will connect to the LAN using 100 Mbps/Full Duplex.
TANDBERG MCU
46
- Quick Links:
- Mcu Configuration
Hide quick links:
Advertisement
Table of Contents
