Initial Configuration - TANDBERG MPS User Manual

TANDBERG MPS User Manual
2.1 Initial configuration
The TANDBERG MPS requires some basic configurations before it can be used. This can be done through the Liquid
Crystal Display on the front of the chassis. It will be necessary to configure the IP-address of the System Controller
Board.
Please refer to Appendix 3: LCD Display Menu Structure for details.
Initial configuration
To do the initial configuration of the IP-address of the System Controller Board and Media Board through the Front
Panel, follow the instructions below:
1. Switch on the TANDBERG MPS by setting the power switch button on the back to '1', see Figure 2‑3. ����
��� ��wer �wi��� and Figure 2‑4. ���� 2�� ��wer �wi��� for details. The system is ready for configuration
when the Power and Active LEDs on the Media Processing Boards are green and the menu appears on the
LCD.
2. Press the up arrow button to get to the start menu.
3. Press the confirm button
4. Press the confirm button
5. Use the arrow buttons to set the following parameters:
• IP: Defines the static IP address of the System Controller Board
• SNM: Defines the static IP Subnet Mask for the network
• GW: Defines the static IP Gateway address
• IF Speed: Defines the Ethernet speed
6. Use the arrow buttons to select Media IP Config and press the confirm button
7. Press the confirm button
8. Use the arrow buttons to set the following parameters:
• IP: Defines the static IP address of the Media board
• SNM: Defines the static IP Subnet Mask for the network
• GW: Defines the static IP Gateway address
• IF Speed: Defines the Ethernet speed
9. Restart the TANDBERG MPS.
Accessing the MPS
After configuring the IP-address of the System Controller Board, you may access the TANDBERG MPS by entering
the IP-address of the System Controller Board in a standard Web-browser. You will then be asked to enter a
password. It is not necessary to enter 'User Name'. The default password for the TANDBERG MPS is 'TANDBERG'.
Remember that the password is case sensitive.
TIP
To change the password of the system, you need to log into the Command Line Interface. For information please see
the TANDBERG MPS API
0
D13373.04
LCD Display Menu Structure for details.
to start Parameter Config.
o start the SC IP Config.
t
to start the Media 1 IP Config.
document supplied with the system or on www.tandberg.net.
for details.
The system is ready for configuration
.