Parallel Dial; Sending Complete - TANDBERG MCU User Manual

Configure the MCU
Configuration
PRI Protocol
Select between the following PRI protocols:
•
ETSI (Euro ISDN)
•
National ISDN
•
AT&T Custom
All PRI lines must use the same PRI Protocol.

Parallel Dial

On Channels will be dialed and connected in parallel when setting up a BONDING call.
Off Channels will be dialed sequentially, which may increase call setup time.

Sending Complete

On The MCU will send the ISDN message information element "Sending Complete".
Off The MCU will not send "Sending Complete".
Send Own Number
On The MCU will send its own number to the far end.
Off The MCU will not send its own number to the far end, but please note that the network may still send
your number to the far end.
PRI Trunk Grouping
When Trunk Grouping is enabled, PRI 2, 3 and 4 will use the same number range as specified for PRI 1.
NSF - Non Standard Facility
Your network provider may require a service selection in your ISDN configuration. Enter the Service code here.
Valid NSF service codes are from 1 to 31. Enter 0 to disable NSF service codes.
TANDBERG MCU
42