TANDBERG MCU User Manual page 20

Using the MCU
Legacy Mode
Floor to Full Screen
Billing Code
Video
Picture Mode
TANDBERG MCU
When connecting older videoconferencing endpoints to the MCU, problems can
occur since older equipment sometimes do not handle modern capabilities.
When selected, some capabilities are not being sent from the MCU. Please refer
to the software release document for more information.
This function only applies for the Continuous Presence 5+1 and 7+1 layout.
When selected, the participant requesting the floor, will be shown in full screen
to all the other video participants, regardless of current speaker. The same will
happen if the conference administrator 'Assign Floor' to a site.
When unselected, the participant requesting the floor, will be shown in the larger
quadrant of the 5+1 or 7+1 layout.
When defining a conference, a specific billing code can be assigned to it. All
calls in this conference will be associated with this billing code. Management
tools, such as the TANDBERG Management Suite, can then use it for billing
purposes.
Defines the picture layout for the conference.
Auto (Best Impression
Voice Switched will show the current speaker in full screen to all the other
participants, regardless of how many participants in the conference. Current
speaker will see the previous speaker.
Enhanced CP will automatically select the most suitable picture layouts
depending on the number of video participants in the conference. For up to two
video participants, both sites will receive a full screen view of the far end. For
three to six video participants, the Continuous Presence 5+1 mode is used. For
seven and more participants, the Continuous Presence 7+1 mode is used.
Traditional CP will automatically select between Continuous Presence 4 mode,
Continuous Presence 9 mode and Continuous Presence 16 mode. For up to two
video participants, both sites will receive a full screen view of the far end. For up
to four video participants, the Continuous Presence 4 mode is used. For five and
up to nine, the Continuous Presence 9 mode is used. For ten and more
participants, the Continuous Presence 16 mode is used.
20
) will automatically select Enhanced CP (see below).
TF