Subscribe to Our Youtube Channel
Related Manuals for TANDBERG D5029302
Summary of Contents for TANDBERG D5029302
- Page 1 User Setup Manual D5029302 This document is not to be reproduced in whole or in part without the permission in writing from:...
-
Page 2: Trademarks And Copyright
Tel: 703-709-4281, Fax: 703-709-4231 All rights reserved. This document contains information that is proprietary to TANDBERG. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form, or by any means, electronically, mechanically, by photocopying, or otherwise, without the prior written permission of TANDBERG. -
Page 3: Operator Safety Summary
TANDBERG MediaPlace Videoconferencing System [ 3 ] Operator Safety Summary For your protection, please read these safety instructions completely before operating the equipment and keep this manual for future reference. The information in this summary is intended for operators. Carefully observe all warnings, precautions and instructions both on the apparatus and in the operating instructions. -
Page 4: Table Of Contents
Trademarks and copyright ................... 2 Operator Safety Summary ....................3 Warnings ......................... 3 Introduction ..........................5 At a Glance: TANDBERG MediaPlace................. 6 TANDBERG MediaPlace Overview ..................7 Unpacking the TANDBERG MediaPlace ..............7 Codec ......................... 7 Integrated W.A.V.E Camera ..................7 Amplified Speaker ....................... -
Page 5: Introduction
MediaPlace offers a flexible, interactive solution that is highly durable, mobile, and SYSTEM secure. Simple to install and set-up, the TANDBERG MediaPlace is designed with ease of WARNING mobility to take the system to where it is needed. This complete, integrated,... -
Page 6: At A Glance: Tandberg Mediaplace
[ 6 ] INTRODUCTION TANDBERG MediaPlace Videoconferencing System At a Glance: TANDBERG MediaPlace security key locks (2x) LEXAN cover with lift handles interface panel w/ storage area SVGA projector hooks for remote control (2x) amplified speaker storage area w/ door... -
Page 7: Tandberg Mediaplace Overview
TANDBERG MediaPlace Videoconferencing System INTRODUCTION [ 7 ] TANDBERG MediaPlace Overview This section provides a general overview of the TANDBERG MediaPlace videocon- ferencing system and some of its optional components. The MediaPlace system comes in three boxes. Unpacking the TANDBERG MediaPlace... -
Page 8: Mobile Cart
Microphone A high-quality, unidirectional table microphone is included with the TANDBERG codec. It is specifically designed to be used on a table during a videoconference. The system will automatically equalize sound levels where loud and soft voices are picked up and transmitted to the far end at approximately the same level. -
Page 9: Remote Control
TANDBERG MediaPlace Videoconferencing System INTRODUCTION [ 9 ] Remote Control The TANDBERG remote control is used to control all codec HE MOBILE CART HAS TWO REMOTE CONTROLLER HOLSTERS functions of the MediaPlace system. If the screen saver or TANDBERG ONE FOR THE... -
Page 10: Installation
INSTALLATION TANDBERG MediaPlace Videoconferencing System Installation The TANDBERG MediaPlace components are: TANDBERG set-top codec (770/880/ 990), lockable mobile cart, high resolution projector, DVD/VCR combination unit, and audio system with speaker and microphone. Refer the following pages for system setup and installation. -
Page 11: Installing Components
The TANDBERG set-top codec must be mounted to the adjusting shelf of the mobile cart. Refer the following illustration for mounting the codec. HE ADJUSTING SHELF CAN BE 1. Insert the white, plastic nut inserts into the bottom of the TANDBERG set- REMOVED FROM THE CART IF top codec. -
Page 12: Installing Projector
[ 12 ] INSTALLATION TANDBERG MediaPlace Videoconferencing System Installing Projector The projector must be mounted to the adjustable projector bracket that is already installed on shelf of the mobile cart. The top half of the projector mount is to be installed to the projector with the parts from the . - Page 13 TANDBERG MediaPlace Videoconferencing System INSTALLATION [ 13 ] Attaching Projector to Cart 1. Find the set of cables tie-wrapped to the projector bracket on the mobile cart. Cut the tie-wrap and set cables aside so that you will be able to properly attach the projector.
-
Page 14: Cable Connections
[ 14 ] INSTALLATION TANDBERG MediaPlace Videoconferencing System Cable Connections The TANDBERG MediaPlace has an easy access A/V interface panel found just behind the system’s amplified speaker. This panel connects to the codec and to network. Audio Connections D5029302... -
Page 15: Video Connections
TANDBERG MediaPlace Videoconferencing System INSTALLATION [ 15 ] Video Connections Network Connections D5029302... -
Page 16: Video Configuration - Projector And Codec
[ 16 ] INSTALLATION TANDBERG MediaPlace Videoconferencing System Video Configuration – Projector and Codec 1. When all of the necessary codec and projector connections have been made, turn the devices on. • The CODEC power switch is located on the rear of the CODEC. -
Page 17: Servicing
If the apparatus has been subject to excessive shock by being dropped. If the apparatus does not operate normally when following the operating instruc- tions. NOTE: TANDBERG will provide on request circuit diagrams and component parts list of the system. For servicing, please contact one of our service centers.
Need help?
Do you have a question about the D5029302 and is the answer not in the manual?
Questions and answers