Mcu Features - TANDBERG MCU User Manual

Configure the MCU

MCU Features

Experience has shown that new standardized features might cause interoperability problems between legacy video
conferencing products. If you disable features on this page, the MCU can be used as a filter to ensure
interoperability with legacy products.
To configure the MCU features, open 'Features' as shown in the figure below.
Video
Enable H.264 Allows H.264 video capabilities to be transmitted through the MCU. When disabled no H.264
video capabilities will be transmitted.
H.264 is supported in Voice Switched conferences and conferences with Continuous Presence 4
layout.
H.264 will be disabled if not supported by the video participants, if Duo Video is active, if more
than one conference is active on the MCU or if Continuous Presence 5+1, Continuous Presence
7+1, Continuous Presence 9 or Continuous Presence 16 is selected.
Network
Enable H.323 Allows IP participants in a conference. When disabled no H.323 traffic is allowed.
Save
Press 'Save' to activate the new settings.
TANDBERG MCU
56