Installing The Hardware; Installing The Mvme167 In The Chassis - Motorola MVME167 Series Installation Manual

Installing the Hardware

This section covers

Installing the MVME167 in the Chassis

Note that if the MVME167 is to be used as system controller, it must
installed in the left-most card slot (slot 1), otherwise it may be installed in
any unused double-height card slot.
Table 3-9. MVME167 Installation Procedure
Step
Remove IACK and BG jumpers from backplane
1
MVME167 is to be installed in.
2 Carefully slide the MVME167 into the card slot in the front of the chassis.
The MVME167 requires power from both P1 and P2. Be sure the
module is seated properly into the P1 and P2 connectors on the
backplane.
Do not damage or bend connector pins.
Fasten the MVME167 in the chassis with screws provided, making
good contact with the transverse mounting rails to minimize RFI
emissions
Installation of the MVME167 into a VME chassis
Overview and installation of transition modules and adapter
boards
Connection of peripheral equipment such as console
terminals, optional SCSI drives, and serial or parallel printers
Installing the Hardware
Action
for the card slot that the
3
3-15