Yamaha YZ250N Owner's Service Manual page 170

FRONT BRAKE PAD INSPECTION AND REPLACEMENT
9Loosen the pad pin 2.
9Remove the brake hose holder 3 and
caliper 4 from the front fork.
9Remove the pad pin and brake pads 5.
9Connect the transparent hose 6 to the
bleed screw 7 and place the suitable con-
tainer under its end.
9Loosen the bleed screw and push the
caliper piston in.
cC
Do not reuse the drained brake fluid.
9Tighten the bleed screw.
Bleed screw:
6 Nm (0.6 m•kg, 4.3 ft•b)
9Install the brake pads 8 and pad pin.
NOTE:
9Install the brake pads with their projections
a into the caliper recesses b .
9Temporarily tighten the pad pin at this point.
9Install the brake hose holder 9 and caliper
0 and tighten the pad pin q.
NOTE:
Fit the brake hose holder cut c over the pro-
jection d on the front fork and clamp the
brake hose.
Bolt (caliper):
23 Nm (2.3 m•kg, 17 ft•lb)
Pad pin:
18 Nm (1.8 m•kg, 13 ft•lb)
3-20
INSP
ADJ